Macht Schnell - Electronic Dampening Control (EDC) Emulation Module

For those who have fitted an aftermarket suspension system, and do not want to have error codes on the onboard computer, the Macht Schnell EDC emulation module is just the thing.

EDC monitoring once the OE dampers are removed can be a bit intrusive on the drivers attention. The on board computer will attempt to communicate an error if the original equipment EDC dampers are disconnected, resulting in numerous error messages thinking that the system has malfunctioned. The MS Emulation Module installs in less than 15 minutes and will fully emulate a fully active EDC environment when activated. The module can be activated/deactivated by via the integrated mini USB port within the module housing and is an inexpensive permanent solution along with any aftermarket suspension system you chose to fit.

The Macht Schnell EDC Emulation Module is possible of the following features:
- The ability to run aftermarket racing suspension/coilover setups in which EDC monitoring is not required
- Compatible with iDrive and non-iDrive systems
- Easy 15-minute installation process with no wire cutting
- Proper emulation of the EDC monitoring system
- No dealer visits or coding required after installation
- Completely removable at any time

Note: The Macht Schnell EDC Emulation Module will disable the EDC monitoring system supplied by BMW. For this reason, this module is not intended for street vehicles or to "hide" codes from a malfunctioned original equipment system. Ignoring a malfunctioned OE system can result in possible injury or death if proper conditions are not followed. Please only use this module for its intended use.

Models Supported:
2008+ E9X M3
2005-2010 E60 M5
2005-2010 E63/4 M6
2007+ E70 X5 & X5M
2008+ E71 X6 & X6M